Please prepare Macmini by yourself.We offer only AndMacmini_Intel.
Please take apart as the above photo.
Do not lose the screws.
Attach the lower arm to L-shaped body.
Fasten the screw temporarily by driver ; not too tight.
Please fasten six spots.
Cut the gel sheet into four
pieces.(Click here for details.）
Put two of the gel sheets without dust on the bottom.
Put Macmini. Do not scratch and keep clean Macmini.
Fit into the main body. （When you fail to do it, please try it again carefully not to scratch.）
Fit the DVD slot with the center of the power supply light.（Otherwise, you cannot put in and out DVD media.）136mm
Put the back board. Fasten two screws temporarily.
Do not lay down from now until finishied.
Check and find if you can see the connector form the back side. （If you fail to attach, you cannot see the connector.)
Put the two pieces of gel sheet on the top of the Macmini without dust.
Cover the top.
Fit the upper cover properly.
Put the upper arm.
Fasten eight screws temporarily.
Put the left cover.
Fasten four screws.
Put the right cover. The air hole of the side cover should be on the bottom of Macmini.
Fasten four crews.
Finally, tighten all of the screws.
********ATTENTION!***********
When you fasten screws, please be sure to put Macmini levelly.
Otherwise, you will scratch Macmini.
As you can see, Andmacmini_Intel and Macmini are attached only by the gel sheet.

Again, please be sure to use AndMacmini_Intel the way you see in the reference photo. Otherwise, it does not fit to Macmini properly, and you may fail to use DVD media.
When you fasten screws, please be sure to put Macmini levelly.
Otherwise, you will scratch Macmini.
As you can see, Andmacmini and Macmini are attached only by the gel sheet.

Again, please be sure to use AndMacmini_Intel the way you see in the reference photo. Otherwise, it does not fit to Macmini properly, and you may fail to use DVD media.