How to assemble DressCubeTwo + Unit
as a bear bone

Attention!

We will recommend this item for those who know about the structure of Cube itself to some extent. Beginners or people who are not good at disassembling machines should be more careful.
Please buy PowerMacG4 Cube in advance. We only offer DressCubeTwo.
Please assemble carefully.
Please remove above parts of Cube carefully.
 Remove the six screws on the internal frame by an exclusive screw driver. You cannot remove them with a Phillips driver.
Please attach the right and left board by the M3.5 screws correctly. If you want to reassemble parts of Cube, please do so before putting the six screws in.
'Unit' is completed.

Move to the next step!
Please prepare DressCubeTwo
 Please remove the bottom arm of DressCubeTwo,
and then, please slide it slowly, as you can see in the photos.
As you can see in the photos, put the screws through the DressCubeTwo and Unit at same time.
Finally, fasten them with the prepared three by six nuts.
Please put the long M3 screws at four spots.
Finished!
Please use habitually for a long time!
Additional parts; CD cover parts(Only one is provided for free. Please refrain from asking for more.)
When DressCubeTwo is used as a 'Unit,' dust tends to collect in the CD slot because the slot is different from original acrylic bear bone's design.
The CD cover parts avoids dusts to some extent. It is made of genuine aluminum, not anodized.
Please do not forget to remove this part, when you put out medias like CD-ROM etc.